Samsung NC10 laptop is the latest issued by the samsung, laptops have this feature is quite powerful battery. The lack of this laptop is the default RAM only 1GB. That will be felt very inadequate. But do not worry, upgrading RAM for Laptops Samsung NC10 is very easy. Following ways to change RAM. Previous prepare a screwdriver and 1 RAM 2GB DDR2 PC5300 SODIMM as a substitute, because this laptop only have 1 slot RAM.
Step by Step Upgrading:
- Turn the NC10 over so its bottom is facing you.
- Loosen and remove the screw holding the upgrade hatch in place.
- Pry off the hatch.
To remove the existing RAM:
- Gently pull the retaining clips holding the presintalled DIMM in place until the module pops loose.
- Pull out the old DIMM and place it to the side. You won’t need it anymore.
To insert a new DIMM into the Samsung NC10:
- Pick up the DIMM and position it so that the teeth are facing the slot and the groove on the DIMM aligns with the notch in the slot. Most likely, the DIMM will need to be placed sticker down.
- Insert the DIMM at a 45-degree angle, pushing until it snaps into plaece and the retaining clips snap into the grooves on either side of it.
The Last Step :
- Snap on the upgrade hatch.
- Insert and tighten the screw holding the upgrade hatch in place.
- Power on the computer. If the computer fails to boot (particularly if you hear a beep), remove the battery to kill the power and open up the chassis again. Your new DIMM is either installed incorrectly or is the wrong kind of DIMM.
- Hit the F2 key right away to enter the BIOS.
- Select the Main tab. You should see the new amount of RAM.
- Hit Esc to exit. You can choose to save changes or not. It doesn’t make a difference.
Recent Comments